The reinforcement technology of steel back ridge support is directly related to the project cost, construction progress and construction quality. Therefore, improving the technical level of formwork support and reinforcement can promote the rapid development of China's construction industry. In China, the traditional reinforcement technology mainly adopts round tube wood reinforcement, which consumes a lot of wood, is not environmental friendly and has less turnover times, resulting in a lot of waste

What are the advantages of the new steel back beam support and reinforcement technology compared with the traditional reinforcement

1. Low cost

The single use cost of the new steel back beam support and reinforcement system is higher than that of the traditional reinforcement system, but the turnover times can reach more than 500 times, which is lower than the traditional cost

2. Good molding effect

The new steel back ridge reinforcement system replaces wood with steel, has high support strength and large bearing capacity, and eliminates the phenomena of formwork expansion, formwork running and slurry leakage. After formwork removal, the effect of clean wall can be achieved without secondary plastering, and the measured average value can reach more than 95%

3. Wide scope of application

It is applicable to walls, beams, columns and roofs with strong universality

4. Short construction period

The installation and removal of the new steel back ridge formwork reinforcement system is very simple, the components are standardized, and the installation does not need guidance. The new steel back ridge reinforcement system uses steel instead of wood, which is green and environment-friendly, greatly improves the construction quality, and can realize one-time molding without secondary rework.